|
Internet Special:
2006 Epilog Legend 36EXT - 60 watt - 36" x 24" w/ 12" of height clearance - Air Assist, Red Dot, Auto-Focus, Integrated Cutting Table 6 month Bumper to Bumper warranty This system looks and feels like new
$22,500
Flash
|
|
|
|
|
|
|
|
Home  Knowledge Advanced Topics Ganging Trophy Plates for Laser Engraving
|
|
Ganging Trophy Plates for Laser Engraving |
|
|
|
|
Written by DCB
|
|
Wednesday, 31 December 2003 |
|
The absolute best way to do this is to engrave all of your trophy plates at once and then using a guillotine-type cutter to break them up. To place your artwork in CorelDraw look under the arrange menu at the transform command. This will pull up a docker on the right hand side that will allow you to move your images. Use the "position" transformation and put in sizes that would move your trophy plate into the next stop. For instance, if you had a 1" x 3" plate you would chose your artwork and then put in 3" (to move it 3" over) and click on "Apply to duplicate." This creates a duplicate image that is 3" over. Repeat this until your entire table is arranged the way that you want it.
|
|
|
|
